![]() ![]() Therefore when using the Series 5 controller, Adaptec Storage Manager can be directly used to gauge current temperature in relation to the maximum operating temperature.įailure to provide adequate space and proper airflow may result in undesired results and render the controller inoperableĪnother FAQ states that "an alarm will sound between 85C and 90C". * On the Series 5, the temperature displayed is the actual die temperature. Therefore when using a Series 2 controller, the maximum operating temperature will be lower then temperature reported within Adaptec Storage Manager. * On the Series 2, the temperature displayed is the board temperature and not the die temperature. When using Adaptec Storage Manager to monitor controller temperature, please be aware that the controller temperature displayed differs slightly between the Series 2 and the Series 5 controllers. These controllers employ passive cooling technology and will require adequate space surrounding the controller to leverage proper internal system airflow mechanics. Note: If a battery unit is installed on a Series 5 controller, please see ASK Answer ID 16907 for additional temperature requirements. ![]() ![]() ![]() Type help to get more details about a particular command.įor more detail information see twi_cli's documentation.The operating ambient temperature requirement for the Series 2 and Series 5 Adaptec RAID controllers is 0☌ to 55☌ (with 200 LFM airflow), with a maximum operating die temperature of 100☌. The controller-qualifiers of the Enclosure commands (/ex) also apply to EnclosureĮlement specific commands (e.g., /ex/elementx). Please consult the twi_cli documentation for explanation of the controller-qualifiers. ex/tempx Enclosure Temperature Sensor specific commands.Ĭertain commands are qualified with constraints of controller type/model support. ex/fanx Enclosure Fan specific commands. ex/slotx Enclosure Slot specific commands. #INSTALL ADAPTEC STORAGE MANAGER CENTOS UPDATE#Update Update controller firmware from an image file.Ĭommit Commit dirty DCB to storage on controller(s). Rescan Rescan all empty ports for new unit(s) and disk(s). Show Displays information about controller(s), unit(s) and port(s).įlush Flush write cache data to units in the system. All rights reserved.įocus Changes from one object to another. This command writes the log entries to a file.Įxample: arcconf getlogs 1 device tabular > device.logĬopyright(c) 2004-2006 Applied Micro Circuits Corporation(AMCC). Tabular: Displays the log in table format.Ĭlear: Deletes the specified controller protocol.Īrcconf getlogs controller-number device ¦ dead ¦ event > DATEINAME.log You can also specify the following parameters: You can use the following parameters to specify the type of log entries displayed:Įxample: arcconf getlogs 1 device tabularĭEVICE: Shows all log entries with errors the controller could detect on all connected devices.ĭEAD: Shows all log entries where device and disk failures were recorded.ĮVENT: Shows all log entries with information about special events (e.g. Use this command to display the log entries. Use this command to display information about the existing hard disks.Īrcconf getlogscontroller-number device ¦ dead ¦ event This command displays information about the RAID controller, configuration, RAID arrays, available disks and their current state. Use the following commands to view detailed information about the Adaptec RAID controller and configuration: The Adaptec RAID controller is managed with the arcconf command line tool. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |